1/16 Scale .07 SH Engine Pull Starter fits RC Nitro Car Shock Absorbers 1/10 This is a prepainted body

This is a prepainted body shell but requires drilling

Battery pack measures 59mm long x 33mm wide x 30mm high

66mm end to end

Measurement format: Outside diameter x inside diameter x wide

Entire length is 195mm (the thin pole bit is 105mm)

1/16 Scale .07 SH Engine Pull Starter fits RC Nitro Car Shock Absorbers 1/10 This is a prepainted body. 07 SH Engine Pull Starter. May fit other cars below is the measurements.. 8mm Hex Fitting 25mm Length 25mm High Note: Center of pull starter is held together with tape when installing remove the tape and ensure the center does not pop out. If it does the pull starter insides will spring out. Hold it together whilst installing onto the engine. We also stock electric starters to fit this model. Other starters in stock simple ask and give the height